Short answer: If the engine starts only after ten presses on the hand primer, the fuel circuit is draining back while the truck stands. The fuel is returning to the tank through a check valve that is not closing, or the primer diaphragm is passing. Both are small parts, both are cheap, and both are found by watching fuel pressure at the filter head after shutdown.
The behaviour is always the same: overnight stand, long crank, then a start once the primer has been pumped. During the day, restarts are normal because the circuit is still full. That pattern is a drain-back, and no amount of battery or starter work will change it.
The cause is either a check valve in the return line that has lost its seat, a primer diaphragm that has cracked, or an air leak on the suction side that lets the column of fuel fall away.
Fit a low pressure gauge at the filter head outlet, run the engine, then stop it and watch the gauge for ten minutes. A pressure that falls steadily to zero is a drain-back through the return path. A pressure that holds but the engine still cranks long is a different fault and the low pressure circuit is not to blame.
Repeat the test with the return line pinched off, using a hose clamp on a spare section. If the pressure now holds, the fault is the return valve, and it is confirmed without removing anything.
The return valve holds a small spring loaded poppet that opens only above a set pressure. Debris, a worn seat or a broken spring lets fuel flow backwards once the pump stops, and the whole low pressure circuit empties into the tank.
On most builds the valve is a serviceable item. Replace it rather than clean it unless the manual specifies cleaning, because a cleaned seat that is scored will leak again within weeks.
| Test | Result | Conclusion |
|---|---|---|
| Pressure holds after shutdown | Stable | No drain-back, look elsewhere |
| Pressure falls to zero in minutes | Drain-back | Return valve or primer |
| Pressure holds with return clamped | Drain-back confirmed | Return valve |
| Primer loses pressure with outlet capped | Primer fault | Diaphragm or check valve in the primer |
Prime until the primer is firm, then crank with the throttle closed. Do not pump the primer while cranking, and do not crank for more than fifteen seconds at a time, because the high pressure pump is being lubricated by the fuel it is trying to draw.
After the first start, check for leaks at every joint you touched, then leave the truck overnight and confirm the fault is gone before returning it to service.
Valve crack pressures and primer part numbers are model specific. Confirm them in the OEM manual or parts catalogue.
Please contact our team for personalized maintenance guidance and technical support for your Sinotruk HOWO, A7, or T7 trucks. We provide professional advice and recommendations for genuine parts to help ensure the reliable operation of your fleet.
Contact Us
Whenever your truck needs repair, you don’t know how to buy the right parts?
Don’t worry, we have already done this job for you. We have a complete parts list catalog for different models of each truck assembly, you can choose the right catalog to download and collect according to your truck configuration.
When you have a need, you can send us your required list based on this catalog.
Obtain the complete Howo truck parts catalog PDF file and pricing.
Contact Us








