banner-news1
REPAIR FAQ
Back

Sinotruk ABS Wheel Speed Sensor and Tone Ring Faults

Short answer: The wheel speed sensor is the only part of the ABS system that touches the road, and it fails more often than the module. The typical symptoms are an ABS lamp that comes on at low speed, a lamp that comes on after a bump, or an ABS that activates unnecessarily at walking pace.

Three checks cover most cases: the sensor gap, the tone ring condition and the wire including its connector.

None of them require a laptop, and all three are faster than replacing a sensor on suspicion.

QUICK DIAGNOSIS — sensor, ring or wiring
  1. 1Lamp at low speed only — Sensor gap too large or dirty tone ring.
  2. 2Lamp after a bump — Damaged wire or connector at that wheel.
  3. 3ABS activates at walking pace — Incorrect gap or a cracked tone ring.
  4. 4Lamp with no wheel signal at all — Open sensor or wiring.
Wheel speed sensor mounted at a truck wheel hub with its tone ring behind the hub

Gap, tone ring, wiring. Three checks find most ABS faults without a laptop.

1. Gap and tone ring

Measure the gap between the sensor and the tone ring with a feeler gauge, and compare to the specification. A gap that has opened up because of bearing play gives a weak signal at low speed.

Then inspect the tone ring for cracks, missing teeth or buildup of debris. A ring with a chipped tooth produces a signal dropout at the same wheel position every revolution.

  1. Measure sensor gap at the specified point. Compare with the specification.
  2. Inspect the tone ring for cracks and debris. A missing tooth shows as a repeating dropout.
  3. Check hub bearing play. Play changes the gap dynamically.
  4. Clean the ring and re-test. Debris is a common and cheap fault.

2. Wiring and connector

The sensor wire runs close to the wheel and takes vibration, water and gravel. Check the connector for corrosion and the wire for chafing near the hub and along the frame.

Measure resistance at the sensor and again at the module connector. A reading that changes between the two points is a wiring fault, not a sensor fault.

Check Finding Action
Gap too large Wear or impact Re-set the gap or replace the hub part
Tone ring damaged Missing teeth or crack Replace the ring
Resistance changes along the wire Chafed loom Repair the wire
Correct gap, ring and wire Module or sensor Swap the sensor to confirm
Tone ring inspected for cracks and debris behind a truck wheel hub

A chipped tooth causes a repeating dropout at one wheel position. It is visible if you look.

3. Confirm before replacing

Before fitting a new sensor, swap a known good sensor from another wheel to the suspect position. If the fault moves with the sensor, the sensor is faulty; if it stays, the fault is the ring, the hub or the wiring.

After repair, drive the truck and confirm the lamp stays off through low speed, turning and braking.

Never drive with the ABS lamp on and assume the truck brakes normally. ABS failure changes stopping distances on wet surfaces and can affect trailer brake balance.
ABS lamp behaviour checked during a low speed road test after sensor repair

Low speed, turning and braking. All three must leave the lamp off before the repair is signed off.

Questions drivers ask most

Can I clean a tone ring?
Yes. Debris and rust scale cause signal faults and cleaning often fixes them.
How do I know the module is at fault?
Only after the sensor, ring, gap and wiring at every wheel have been proven good.
Why does ABS activate at walking pace?
A weak or intermittent signal at one wheel. Check gap and ring first.
Do trailer ABS faults affect the tractor lamp?
Yes on some systems. Check the trailer too before condemning tractor parts.
Need ABS sensors, tone rings, hub parts or ABS modules? Send the axle model and we will confirm. Send your request

Sensor gaps and part numbers are axle specific. Confirm them in the OEM manual.

Need Help or Want More Detailed Maintenance Information?

Please contact our team for personalized maintenance guidance and technical support for your Sinotruk HOWO, A7, or T7 trucks. We provide professional advice and recommendations for genuine parts to help ensure the reliable operation of your fleet.

Contact Us
More Articles

Howo Sinotruk Parts & Catalog PDF

Whenever your truck needs repair, you don’t know how to buy the right parts?

Don’t worry, we have already done this job for you. We have a complete parts list catalog for different models of each truck assembly, you can choose the right catalog to download and collect according to your truck configuration.

When you have a need, you can send us your required list based on this catalog.

Obtain the complete Howo truck parts catalog PDF file and pricing.

Contact Us

Hot-Selling Replacement Parts

whatsapp-4