Short answer: The crown wheel and pinion in a final drive must mesh with a specific backlash and a contact pattern that sits in the correct part of the tooth face. Both are set with shims, and both must be correct together: a pattern that looks acceptable with the wrong backlash will still whine, and a backlash that measures correctly with the pattern in the wrong place will wear out in a few thousand kilometres.
The complaint after a rebuild is a whine on drive or on overrun, and the cause is almost always one of the two settings, or a pinion depth that was never checked.
The procedure needs marking compound, a dial gauge and patience. It is not a job that can be done by feel.
Measure backlash at several points around the crown wheel and confirm it is within specification and consistent. A variation around the wheel means a distorted or incorrectly seated crown wheel.
Then apply marking compound and turn the pinion under load in both directions. Read the pattern on the drive and coast sides of the tooth.
Carrier bearing preload and pinion preload both affect the pattern and the noise, so set them before the final pattern check. Overtight preload produces heat and noise that no pattern adjustment will remove.
After assembly, use the specified oil, fill to the correct level and follow a break-in procedure with a load check and a temperature check after the first run.
| Symptom | Cause | Action |
|---|---|---|
| Whine on drive | Pattern near the toe | Move pattern toward the heel |
| Whine on overrun | Pattern near the heel | Move pattern toward the toe |
| Noise hot only | Preload or oil | Check preload and oil |
| Backlash varies | Crown wheel not seated | Re-seat and re-measure |
After reassembly, run the truck loaded for a short distance, then check the axle temperature and listen for noise. A correct setup runs cool and quiet.
Check the oil for metal after the first few hundred kilometres. Fine particles are normal during break-in; flakes are not.
Backlash and preload values are axle specific. Confirm them in the OEM manual.
Please contact our team for personalized maintenance guidance and technical support for your Sinotruk HOWO, A7, or T7 trucks. We provide professional advice and recommendations for genuine parts to help ensure the reliable operation of your fleet.
Contact Us
Whenever your truck needs repair, you don’t know how to buy the right parts?
Don’t worry, we have already done this job for you. We have a complete parts list catalog for different models of each truck assembly, you can choose the right catalog to download and collect according to your truck configuration.
When you have a need, you can send us your required list based on this catalog.
Obtain the complete Howo truck parts catalog PDF file and pricing.
Contact Us








